Restoring a $400 Auto-5: parts, fit and finish that matter
A writer at Gun Digest picked up a well-worn FN-made Browning Auto-5 for $400 and turned it into a months-long restoration project for his wife, replacing worn parts and refitting the stock to her 12.5-inch length of pull.
Snapshot
The piece walks through a DIY rejuvenation of an early Belgian-made Auto-5, likely dating to the 1920s based on its serial number and proof marks. The author and his wife tackled a cracked forend, mismatched wood finish and an ill-fitting stock, then sent the metal out for professional bluing and chamber work. The result, according to the author, is a shotgun restored to shoot and fit well rather than just look old.
Key points
- Action upgrade: The original wooden spring plug was swapped for a machined-aluminum Sure Cycle Auto-5 Action Cycle Kit.
- Forend repair: A crack at the forend's base was filled with Miles Gilbert BedRock bedding compound, tinted to match the walnut grain, while Citristrip and careful sanding preserved the factory checkering.
- Stock fitting: A new stock blank was cut to a 12.5-inch length of pull, fitted with a Pachmayr F325 Deluxe recoil pad, and hand-shaped to match the receiver tang.
- Finish work: The wood was stained with a homebrew Minwax mix and finished with about 10 hand-rubbed coats of thinned Birchwood Casey True Oil.
- Metal and chamber: Finks Custom Gunsmithing in Paulden, Arizona, reblued the metal, parkerized the forend cap, and opened the chamber to accept 2¾-inch shells.
Quick take
The author's experience shows that a neglected but structurally sound classic can be brought back without exotic tools, as long as the person doing the work is patient with sanding, fitting and finishing. For gun owners who value older shotguns and like working wood and metal themselves, this project is a reminder that affordable parts and careful prep can rescue a gun others might pass over.
Read the full story: gundigest.com