Last night, PHLster Holsters had a live-stream event where they announced their new product, the Modular Holster Wedge Kit. Some may not think this is a big deal, but I can’t wait for my kits to try out.
I’ve been using foam wedges ever since I switched to appendix carry. I’ve used foam wedges from KSG Armory, Dark Star Holsters, and ones I’ve made out of foam yoga blocks. Premade wedges can get the job done but don’t give you any room for adjustments. DIY wedges at home work great as you can make tiny adjustments to dial them in. But that is a process that can take some time. I’ll admit I’ve often been lazy and went with wedges that “worked good enough.”
Enter the PHLster Modular Holster Wedge Kit. These are air-sealed foam with a comfortable fabric outer layer that can be velcroed to the holster and themselves. This allows you to mix and match the different shapes to fit your body style and the way you carry.
Each pack comes with 12 total wedges in different sizes, allowing you to make wedges for two holsters for $44.00.
BUY PHLSTER MODULAR HOLSTER WEDGE KIT
PHLster Modular Holster Wedge Kit
Fine-tuning holster fit to the body is the most time-consuming and individual aspect of concealed carry. Huge gains in comfort and concealment can be accomplished by adding a wedge to the holster, but getting that wedge just right is often a big project, full of trial, error, frustration, and guesswork.
The Modular Holster Wedge Kit provides a variety of stackable shapes which you can use in any combination or configuration to quickly and easily get the comfort and concealment results you need, with no permanent modifications to the holster.
WHAT IT COMES WITH
Two base pads, two spines, four half-circles, and four “bean” shapes, pre-cut hook tabs for each shape, and two pieces of adhesive loop.
For a total of 12 wedge modules, this is enough to adjust two holsters, with enough modules and material left over to fine-tune an extra magazine carrier or knife sheath.
Read the full article here